By July 31, 2015 0 Comments Read More →

ELECTRICAL POWER SYSTEM ANALYSIS

ELECTRICAL POWER SYSTEM ANALYSIS

Yogyakarta | August, 11 – 13, 2015 | Rp 6.000.000,-
Yogyakarta | September 15 – 17, 2015 | Rp 6.000.000,-
Yogyakarta | October 20 – 22, 2015 | Rp 6.000.000,-
Yogyakarta | November 03 – 05, 2015 | Rp 6.000.000,-
Yogyakarta | December 15 – 17, 2015 | Rp 6.000.000,-

 

 

OVERVIEW

A Power System is predominantly in steady state operation or in a state that could with sufficient accuracy be regarded as steady state. In a power system there are always small load changes, switching actions, and other transients occurring so that in a strict mathematical sense most of the variables are varying with the time. However, these variations are most of the time so small that an algebraic, i.e. not time varying model of the power system is justified.
The purpose of this course is to develop a thorough understanding of power system analysis and design as well as the overall capabilities of Power Station. Class room discussion, and problem-solving has been designed to provide the analytical techniques necessary to solve a wide variety of practical problem.




OBJECTIVES

  • Power System Analysis means verifying the adequacy of the power distribution system and it’s components.
  • Recognize coordination related disturbances and outages.
  • Collect the required data to perform a detailed coordination study.
  • Derive complete protective device settings for some of the simpler electrical power systems that are consistent with NEC requirements



OURSE CONTENTS ELECTRICAL POWER SYSTEM ANALYSIS

  • Introduction to Industrial Power Systems
  • Short Circuit Theory and Terminology
  • Effects of Short Circuits
  • Fault Current Sources
  • Machine Reactances
  • Fault Current Characteristics
  • Electrical Equipment Ratings
  • Fuses
  • Circuit Breakers
  • Motor Starters
  • Conductors and Bus
  • Balanced Fault Calculations
  • Coordination Fundamentals
  • Procedures
  • Data Collection
  • Scaling Factors
  • Plotting Time/Current Curves
  • Circuit Breakers
  • Fuses
  • Time Delay/Instantaneous Relays
  • Relay Coordination Intervals
  • Equipment Protection and Coordination
  • NEC and ANSI/IEEE Criteria
  • Conductors (Low and Medium Voltage)
  • Transformers
  • Motors e. Conductors (Low and Medium)



WHO SHOULD ATTEND

This course is intended for anyone who must perform calculations, provide settings or approve the work performed by others. The trainee should be a graduate engineer or have the equivalent practical work experience in electrical power systems.



METHODS

  • Presentation
  • Discussion
  • Practice
  • Case Study
  • Evaluation



INSTRUCTOR

Tugino, S.T., M.T. & Team
(expert in Electrical Power System Analysis and Instrumentation)

TIME & VENUE

  • Batch 8 : August 11 – 13, 2015
  • Batch 9 : September 15 – 17, 2015
  • Batch 10 : October 20 – 22, 2015
  • Batch 11 : November 3 – 5, 2015
  • Batch 12 : December 15 – 17, 2015
  • 08.00 am – 16.00 pm (WIB)
  • Ibis Malioboro Hotel Yogyakarta ; Jambuluwuk Malioboro Hotel Yogyakarta ; Horizon Hotel Yogyakarta ; Phoenix Hotel Yogyakarta

In House Training : Depend on request



TUITION FEE

6.000.000 IDR /participant (non residensial)*

Special Rate:

5.500.000 IDR (min 4 participants from the same company)



FACILITIES

  • Meeting Room at Hotel
  • Module/Materi (hard & soft copy)
  • Training Kit
  • Coffe Break & Lunch
  • Souvenir
  • Sertifikat
  • Airport pick up services
  • Transportation during training

Share and Enjoy: These icons link to social bookmarking sites where readers can share and discover new web pages.
  • MisterWong
  • Y!GG
  • Webnews
  • Digg
  • del.icio.us
  • StumbleUpon
  • Reddit
Posted in: Electrical, Yogyakarta

About the Author:

Post a Comment